I had no idea you could wash the printhead.
After washing the printhead I finally have a perfect running printer again. Printer then cycles and starts up normally.ĩ) I was having clogged jets and doing cleaning cycles periodically and was not able to clear the clogged jets. The B200 error code reset fix: Powered the printer off and then back on and while powering back on push the Home Button and Power Button at the same time like 10-15 times repeatedly. Took about 5 minutes and I was very patient.ĥ) Carefully dried printhead with papertowels making sure all electrical contacts were completly dry.Ħ) Reinstalled printhead and all cartrigesħ) Plugged printer back in and turned on and still got the B200 error I washed resevoir first until clear and no more ink visible, then turned upside down and washed underneath printhead until clear, then repeated washing top and bottom about 8-9 times until all ink was gone and ran clear.
#Canon pixma mp990 error b200 how to
***Note had to manually move printhead and cartriges over to the left to remove cartriges and printhead****Ģ) Removed all ink cartriges and carefully put them in separate plastic bags (I didn't have the orange storage clips to seal the base)ģ) Watched youtube video on how to remove printhead for the MP990Ĥ) Watched youtube video on running low pressure warm water under the sink to clean printhead. I fixed this b200 error by searching this forum and following a few steps mentioned.ġ) Tried unplugging the printer for 10 minutes.
0 kommentar(er)
